Dynon Wiring

I started out today by drilling a hole in the firewall for the EMS wires. The thermocouple wires for the EGT and CHT sensors

are fairly large, so the hole is about 1/2″ in diameter.

EMS Wire Hole

EMS Wire Hole

I added a serial plug for the HS34, since I learned that it also needs to be able to receive firmware updates.
Dynon Serial Ports

Dynon Serial Ports

Thermocouple Leads

Those brown wires are the thermocouple leads

D-180 Wiring

The thermocouple wires were already in the connector, so the process was very simple.

I also installed the aileron balance tubes for what will hopefully be the last time. The weather is warming and it’s going to be time for covering pretty soon.

Posted on
Hours Logged This Session: 3.4
Total Hours: 1883.75

Leave a Reply